|
Please note, you will need to take the cover off your current battery pack and replace the batteries with this NiCD High Power 14.4V 2400mAh rechargeable battery pack. Works with all Roomba FloorVac models. Does not fit 500 series models. 6 inch length wires are connected to the batteries for easy installation. Battery Installation Instruction:
Step 1: Take the screws off the top cover of your old battery. A triangle tipped screw driver is included.
Step 2: Open and remove the top cover from the power system, which may be glued. You may need a flat screw driver to pry it off.
Step 3: Remove the old battery inside. There are three wires with metal contacts connected inside. You can remove the wires by pulling up the contact or by cutting the wires off. Take a note of the wire connections.
Step 4: Put new battery into the battery case and solder the three wires back to the metal contacts. Follow the note taken in Step 3 or the following details for re-wiring:
- Red wire : battery positive - The red wire must go to the terminal farthest away from the battery
- Black wire: battery negative - metal contact near edge
- White wire: temp sensor - metal contact on other side
Step 5: Put back the cover
Step 6: Screw on the cover
|