 How to make installation easier, 7.10.2011
|
|
Reviewer: Handyman Dave (Silver Spring, MD, )
|
Here's how I installed it: Since you are presumably replacing a broken coupling it is in two pieces. Removing the side where the blender bowl is attached is easy. Use a wrench or vise to hold the square end. Use a vise grip to hold the broken round coupli
|
|
 Difficult Repair, 5.12.2011
|
|
Reviewer: Number 1 BYU (Utah, )
|
It was not made for easy repair but after too long a time working at it I finally got it repaired. Not for the inexperienced do it your selfer!
Pros: It works great
Cons: Miserable to get apart
Best Uses: See Product Review
|
|
|
did the trick, 3.12.2011
|
|
Reviewer: shan123 (mobile , al, )
|
my husband had it changed in 20 minutes or less. saved us $$$!!
Pros: See Product Review
Cons: None
Best Uses: See Product Review
|
|
|
[...]Good price., 12.12.2010
|
|
Reviewer: rfrank (Tucson, AZ, Tucson, AZ)
|
As advertised
Pros: See Product Review
Cons: None
Best Uses: See Product Review
|
|
|
Perfect part, 11.4.2010
|
|
Reviewer: Skippy the Savior (Land's End, MX, Land's End, MX)
|
This was the exact replacement part for my heavily used blender Up and running like new again Remove the bottom 3 screws, pull the four screws holding the motor, replace the coupling and reassemble The ultimate in recycing is to repair!
Pros: Se
|
|
|
Glad they had the part, 9.21.2010
|
|
Reviewer: the cook (Florida, Florida)
|
So happy they had the parts, Now it's up and running againI would use this site again
Pros: See Product Review
Cons: None
Best Uses: See Product Review
|
|
|
I'm going to buy this item many times., 9.14.2010
|
|
Reviewer: Jacs, the magician... (Chicago ,IL, Chicago ,IL)
|
I was just tired looking for these small parts, thanks TOTALVAC, You got it!!
Pros: Just Perfect
Cons: None
Best Uses: See Product Review
|
|
|
Perfect match, 8.17.2010
|
|
Reviewer: Moncho the handyman (Puerto Rico, Puerto Rico)
|
It's always the weakest link and the much need to replace Not so easy to install in some models but
|
|
|
rubber coupling, 7.22.2010
|
|
Reviewer: smitty (denver colorado, denver colorado)
|
part was tricky to install but when finished blender works great again
Pros: See Product Review
Cons: None
Best Uses: See Product Review
|
|
|
Obscure Parts - Coupling, 4.15.2010
|
|
Reviewer: M & K (Evans, GA, Evans, GA)
|
Just what was needed to keep the relatively new blender in daily service Total Vac was the only place we could find that carried this part along with some other useful parts Very useful resource!
Pros: See Product Review
Cons: None <
|
|
